1:1 BALUNs (50:50)

These are our 1:1 current baluns (50:50 ohms) for balanced antennas fed with 50-ohm coax or ladder line. A 1:1 current balun forces equal current into both halves of the antenna and stops common-mode current from flowing back down the outside of the coax shield. That keeps your radiation pattern intact, your feedline quiet, and RF out of the shack. Every unit is wound with PTFE coax or PTFE wire on large ferrite cores and measured in-house so that resistive choking impedance stays dominant across its band.

Which one fits your antenna?

BL-130-5K (1–30 MHz, 5 kW ICAS, 3,300–6,600 ohms choking impedance): the all-around HF choice for coax-fed dipoles and Yagis. It’s a direct replacement balun for multiband beams such as the Cushcraft A3S/A3WS/A4S and Hy-Gain TH3/TH5/TH6DXX/TH7/TH11.

BL-1030-10K (10–30 MHz, 10 kW ICAS, ~6,000 ohms): for contest and DX stations running legal-limit power into monoband or multiband Yagis on 30–10m. Two 3-inch cores and Thermax PTFE coax.

BL-50-3K (50–54 MHz, 3 kW ICAS, over 7,000 ohms): built specifically for 6m Yagis, dipoles, and quad loops. Available with SO-239 or N-type connectors.

ATU130-5K-1:1 (1–30 MHz, 5 kW ICAS): a tuner balun for doublets, G5RV, ZS6BKW, Zepp, and full-wave loops fed with 300, 450, or 600-ohm ladder line. It mounts at the point where the ladder line meets the coax to your tuner and gives a balanced, choked transition there.

Feeding an OCF dipole or a horizontal loop instead? Those need a 4:1 ratio; see our 4:1 BALUNs. For why current balance matters, read About BALUNs, and for the difference between a balun at the antenna and a choke at the house entrance, see About CMC.

Showing all 4 resultsSorted by popularity

Showing all 4 resultsSorted by popularity